See https://www.youtube.com/video/65uAZwkZxno?ecver=2
How to change the thermocouple offset on a DynaTrol. This helps you calibrate the control to match your kiln.
See https://www.youtube.com/video/OiTFm6wy-tg?ecver=2
How to fix buttons that are not working on an L&L DynaTrol kiln control.
See https://www.youtube.com/video/m-elmu-B9lI?ecver=2
How to change from Degrees F to C on a DynaTrol control.
See https://www.youtube.com/video/xohgXtp-2VA?ecver=2
How to turn off the error codes on a DynaTrol.
See https://www.youtube.com/video/5IZWQMHjxQM?ecver=2
How to enter a cone offset into a DynaTrol.
See https://www.youtube.com/video/JvUuFqPLAK4
How to adjust the amount of power going to a powered bottom using the settings in the DynaTrol.
See https://www.youtube.com/video/5DI3IbGP83g
This shows you how to create a really long program with up to 16 segment of control on your DynaTrol program control.
