KNOWLEDGEBASE

This program is fine for slumping, tack fusing, or full fusing, just substitute different top temperatures when programming. The step in the programming marked with a "*" at the end of it is the one to change.

For slumping use 1220 (Fahrenheit)

For tack fusing use 1350

For full fusing use 1480

You may have to adjust these temps a little higher or lower depending on your tests.

Additionally the 10 minute hold time at the highest temp may need to be adjusted longer or shorter as well. This hold time is the number entered in the next step after the step with the "*" on it.

To enter this program do the following:

1. Set the toggle switch for the kiln to ON
2. Press ENTER, Or if it says to WAIT, do it, then look for "IDLE" to appear along with TC # and the temp inside.
3. Press the following keys:
4. ENTER PROG
5. 1
6. ENTER
7. 8
8. ENTER
9. 500
10. ENTER
11. 250
12. ENTER
13. 12
14. ENTER
15. 500
16. ENTER
17. 500
18. ENTER
19. 12
20. ENTER
21. 500
22. ENTER
23. 750
24. ENTER
25. 12
26. ENTER
27. 600
28. ENTER
29. 1250
30. ENTER
31. 20
32. ENTER
33. 600
34. ENTER
35. 1350*
36. ENTER
37. 10
38. ENTER
39. 9999
40. ENTER
41. 1000
42. ENTER
43. 100
44. ENTER
45. 90
46. ENTER
47. 970
48. ENTER
49. 100
50. ENTER
51. 120
52. ENTER
53. 750
54. ENTER
55. 1
56. ENTER
57. 9999
58. ENTER
59. START

In the future when you want to run this program, you can call it up from the memory and run it by pressing RECALL PROG/ 1/ ENTER/ START.