Even though you know the kiln is not that hot: this indicates a thermocouple failure.
- Check the thermocouple end. Examine the end carefully. Sometimes there can be a crack that opens up while the kiln is hot but appears to be normal when the kiln is cold. If the end of the thermocouple looks severely corroded and you are getting Error codes then it is best to replace the thermocouple.
- Check the thermocouple circuit. For instance, check to make sure that all the thermocouple lead wires are firmly connected. Check where the thermocouple lead wires go into the ends of the thermocouples. Are the wires loose? Tighten the screws on the ends of the thermocouples to be sure you have a tight connection. Check for corrosion. Check where the thermocouples connect to the DynaTrol. Try pulling off each connection and reseating it. This can scrape away corrosion that may have built up. Check for melted wires.
- A very easy check is to check resistance (ohms). Remove the thermocouple lead wires from the thermocouple head and check the resistance with your meter. If the thermocouples and circuit is normal then you will see a resistance of about .9 or 1.0. If you see an OL in your meter then you have an open circuit somewhere which is probably a bad thermocouple.
